The engine equipment on the 2001 Ford Windstar 3.8 are managed by a single accessory drive belt. These equipment embody the water pump, the air conditioner compressor, the alternator and the power steering pump. The belt is routed across the equipment in a course of that enables it to regulate every of the equipment on the identical time from the identical belt. When the engine is working, the crankshaft drives the belt round every accessory. If the belt turns into frayed or has extreme cracking, change it instantly.
2001 Ford Windstar Accessory Drive Belt Replace Instructions
Find the accessory drive belt routing diagram that’s stamped to the top of the radiator shroud. Confer with this diagram when routing the brand new belt across the accessory pulleys. Find the accessory belt tensioner on the front lower left aspect of the engine. Rotate the tensioner from the bolt head that connects the curler pulley to the underside of the tensioner.
Place a metric socket and the breaker bar onto the pulley bolt. Rotate the breaker bar clockwise to launch the stress from the belt. Slide the belt off the tensioner pulley and permit the tensioner to retract till it stops. Pull the belt out of every of the opposite accent pulleys. Slide the belt round every of the fan blades and out of the engine nicely.
Route the brand new belt round every of the fan blades and round every accessory pulley as indicated on the belt routing diagram. Rotate the tensioner counterclockwise with the breaker bar. Slide the belt across the tensioner pulley and launch the tensioner. Remove the breaker bar and socket from the tensioner pulley. Examine the belt to make sure that it’s inside every pulley. Crank the 2001 Ford Windstar 3.8 engine for about 10 seconds to fully match the brand new belt inside of every pulley. Flip the engine off.
[taken from ehow.com]